30W White LED Chip 2100-2500 Lumen 6000-7000K 31-35V 3000mA

Description

What it is

The White LED Chip 30W ARD001568 is a high-power component ideal for projects requiring strong illumination. With a color temperature range of 6000-7000K, this LED chip provides a daylight-like white light.

Features

• Power: 30W
• Luminous Flux: 2100-2500 Lumens
• Variable Operating Voltage: 31-35V
• Maximum Current: 3000mA

What it is for

This LED chip is suitable for projects such as emergency lights, portable lamps, and integrated lighting systems in small spaces. It is compatible with various Arduino and ESP circuits to control the lighting.

Tutorial: How to Use the White LED Chip 30W

The white LED chip ARD001568 is ideal for projects requiring strong illumination in tight spaces. This component is suitable for both beginner and intermediate makers, offering intense lighting with color temperatures between 6000-7000K.

What you need

• Arduino Uno
• LED Driver
• Resistors
• Jumper Cables
• Electronic protection board

Steps

1. Check the LED chip specifications on the datasheet to understand the required power supply.
2. Connect the electronic protection board between the power supply and the LED driver.
3. Connect the jumper wires from the driver to the corresponding pin on the Arduino, using resistors to limit the current.
4. Write an Arduino sketch that controls the LED driver through an output command.
5. Load the sketch onto the microcontroller and verify the power supply to the LED chip.
6. Adjust the input values in the code as needed to optimize the LED brightness.
7. Ensure that the LED chip never exceeds its maximum specifications (check on the datasheet).
8. Physically protect the circuit with a protective container or a protective box.

Example code

void setup() {
  pinMode(9, OUTPUT);
}

void loop() {
  digitalWrite(9, HIGH);   
  delay(1000);              
  digitalWrite(9, LOW);    
  delay(1000);              
}

Mini project

Create a portable LED lamp with the ARD0001568 chip. Use a small container as a base and connect the LED chip to a button to turn the light on and off.

Common mistakes

• Ignore the current specifications of the LED chip.
• Do not use an electronic protection board.
• Omit resistors between Arduino and LED driver.
• Use power supplies that are not compatible with the LED chip.

Recommended accessories

• Variable resistors
• LED driver PWM
• 12V power supply
• Protective container for circuits

Frequently asked questions

Can the ARD0001568 chip be used with other microcontrollers?
Yes, but make sure to adapt the code and circuit configuration based on the chosen microcontroller.

What is the recommended maximum temperature for continuous use of the LED chip?
Check the datasheet. Generally, LED chips require an adequate cooling system to prevent overheating.