12V3528RGB Waterproof RGB LED Tape 60units/m 5M Reel with Controller

Description

What it is

The 12V3528RGB Waterproof RGB LED Tape is a versatile product for indoor and outdoor lighting. This LED tape offers a flexible and ready-to-use solution with the controller included, allowing you to create customized lighting effects.

Features

• 12V3528RGB Waterproof RGB LED Tape
• 60 units per meter
• Roll length: 5 meters

What it is for

The RGB LED tape is ideal for decorative or emergency lighting, both indoors and outdoors. You can use it to create customized lighting in your bedroom or studio, or to decorate walls and control colors via Arduino.

Tutorial: How to Use Waterproof RGB LED Tape

The waterproof RGB LED tape is ideal for decorative or emergency lighting. This tutorial will guide you through the installation and configuration of the tape, enabling you to create fantastic lighting effects in just a few minutes.

What you need

• Waterproof RGB LED Strip
• Arduino Uno/Nano
• JST/JST-SH Connections
• 12V Power Supply
• Ethernet Cable (as connector)
• Arduino IDE Software

Steps

1. Connect the LED strip to the Ethernet cable using a JST connector. Check polarity.
2. Connect the 12V power supply to the LED strip through the JST connector.
3. Connect the following pins of the controller to the Arduino board: GND to GND, VCC to 5V, and DATA to one of the communication pins (e.g., Pin 6).
4. Download the ‘Strips’ example from the menu File > Examples > FastLED.
5. Modify the sketch to specify the number of LEDs in the strip (check the datasheet) and the type of connection.
6. Upload the sketch to Arduino.
7. Check that the LEDs light up following the provided example.
8. Try to modify the sketch variables to create custom effects.

Example code

/* Includi la libreria FastLED */
#include <FastLED.h>

#define NUM_LEDS 60 // Verifica sul datasheet il numero di LED
CRGB leds[NUM_LEDS];

void setup() {
    FastLED.addLeds<WS2812, DATA_PIN>(leds, NUM_LEDS);
}

void loop() {
    FillLEDsRandomColors(leds, NUM_LEDS); // Effetto casuale
}

Mini project

Create an RGB lighting for your room or studio. Use the LED tape to decorate the walls and control the colors with Arduino.

Common mistakes

• Reversed polarity on JST connector
• Incorrect number of LEDs in the code
• 12V power supply not powerful enough
• Data connection to the wrong pin on the Arduino

Recommended accessories

• 12V wall power supply
• Ethernet cable for JST connector
• Kit of JST/SHT connectors
• FastLED library for Arduino

Frequently asked questions

How can I change the colors?
Modify the variables in the code or use the FastLED software.

Can I connect it to a battery?
Yes, but make sure the voltage is between 10V and 12V.

What effects can I create?
From simple color cycles to complex animated patterns.