G1/4 DC12V PE Pipe NC Electromagnetic Valve

Description

What it is

The G1/4 DC12V PE Pipe NC electromagnetic valve is a component used to control the flow of water or other fluids in automated systems. This type of valve activates when a 12V voltage is applied, allowing the fluid to pass.

Features

• Operating Voltage: DC12V
• Internal Thread Size: G1/4
• Construction Material: PE (Polyethylene)

What it is for

The electromagnetic valve can be used in projects such as automatic irrigation systems, water alert systems, or any other application where electronic control of the flow is necessary. It is compatible with Arduino and ESP for programming the opening and closing cycles.

Tutorial: How to Use G1/4 DC12V Electromagnetic Valve

The G1/4 DC12V solenoid valve is ideal for controlling the flow of water or other fluids in automated systems. This component is perfect for projects such as automatic irrigation, water alert systems, or any other application where electronic flow control is necessary.

What you need

• Arduino Uno
• G1/4 Connection
• 12V Power Cable

Steps

1. Connect the positive connector of the valve to the VCC pin of the Arduino and the negative connector to GND.
2. Connect the two terminals of the sensor (IN) to the digital pins of the Arduino for control.
3. Check the system fluid pressure before connecting the valve.
4. Write a simple sketch that controls the opening and closing of the valve through a digital signal.
5. Test the valve with an Arduino program that opens and closes the circuit to verify proper operation.

Example code

void setup() {
pinMode(2, OUTPUT);
}

void loop() {
digitalWrite(2, HIGH); // Apri la valvola
 delay(1000);
digitalWrite(2, LOW); // Chiudi la valvola
delay(1000);
}

Mini project

Create an automatic irrigation system that opens and closes the water based on a sensor condition (e.g., soil moisture).

Common mistakes

• Do not check electrical compatibility before installation
• Incorrect connection between Arduino and valve
• Use of an incompatible fluid with the valve material

Recommended accessories

• Arduino Uno (ARD006478)
• Soil Moisture Sensors (ARD006512)
• Relay Module 5V (ARD006493) for low power applications
• Automatic Irrigation Kit (ARD006520)

Frequently asked questions

Does the valve work with USB power?
No, the valve requires a 12V DC voltage to operate correctly.

What tube diameter is compatible?
The internal diameter of the G1/4 connector must be used with compatible tubes.

How can I control it from a greater distance?
Use a relay to separate the control circuit and the power circuit.