SMB Bend Female to SMB-J Male 100CM RG316 Cable

Description

SMB Bend female inside SMB-J male inside 100CM RG316 cable

Tutorial: How to use SMB Bend female inside SMB-J male cable

This cable is ideal for connecting antennas to uninterrupted transmission systems. Useful for beginners and makers.

What you need

• SMB Bend female inside SMB-J male cable
• Antenna
• SMA connector or equivalent
• Soldering iron and solder wire

Steps

1. Check the internal diameter of the SMB-J connector.
2. Verify the operating frequency of the RG316 cable from the datasheet.
3. Solder the connection between the antenna and the female connector.
4. Insert the RG316 cable into the SMB-J connector.
5. Check the connection and soldering.
6. Connect to a transmission system.
7. Test the connection with a receiver.
8. Verify signal stability.

Mini project

Build a transmission system based on an Arduino module and a receiver.

Common mistakes

• Solder too strongly, damaging the cable.
• Insert the wire without checking the operating frequency.
• Omit the flux.
• Connect the antenna to a transmission system without testing the connection.

Recommended accessories

• SMA Antenna
• SMA Connector
• Soldering iron
• Solder wire

Frequently asked questions

Can the RG316 cable be used for frequencies different from those indicated?
Check the datasheet for the recommended operating frequency.

Can I use this cable with any antenna?
Make sure the antenna is compatible with the SMA connector.

How long does the connection last?
The connection is permanent and requires soldering.

Can you recommend a receiver to test the connection?
Use a receiver compatible with the cable’s operating frequency.