3PCS Vibration switch SW-18015P
1, SW-18015P series of spring-type, non-directional vibration sensor trigger switch can be triggered at any angle.
2, this series is open when the switch is in the OFF state standstill, when touched by the external force to achieve the corresponding vibration force, or moving speed appropriate from the (partial) effort, the conductive pin will produce an instant was an instant turn-on the ON state; When the external force disappears, the switch back to the open OFF state.
3, the series switch model P-bit word is not identified as a completely sealed package.
4, the series switch trigger high sensitivity.
5, under normal use, switch life of up to 200,000 times
6, applicable to toys, burglar alarm, electronic scales and other electronic products.
Package voltage and current on-time closed open resistance temperature resistance
Seal type 12v 5mA 2ms <10 ohm> 10M ohm 80 'C
Names and characteristics of the material
1 spring nickel-plated stainless steel / phosphor bronze wire
2 guided needle nickel-plated brass bottom - Surface gold-plated
3 switch body ABS plastic glue
PVC heat shrink tube heat shrinkable tube 4 / PRT heat shrinkable tube
5 sealed plastic epoxy
Solder: tin content 100%
Soldering temperature: 260 ℃ ± 10 ℃
Soldering time: 2-2.5 seconds
Do not use acid, alkaline flux