Convertitore regolabile DC-DC step down LM2596S alimentatore 5V 12V 2A ARDUINO

1 convertitore DC-DC switching di tipo step down incentrato sullo stabilizzatore     

LM2596S molto compatto misura solo 46x26 mm altezza 12mm   

Tensione di ingresso: da 4,75Vdc a 35Vdc      

Tensione di uscita: da 1,25Vdc a 26Vdc (regolabile tramite trimmer multigiro)    

Corrente di uscita: 2A      

1, the input voltage: 3.2-35 v

Adjust way: first right after the input power supply (3.2-35 v) between the output voltage with a multimeter to monitor and adjust potentiometer (general chronological booster, the backward turn step-down),

2. 1.25 30 v adjustable output the no-load commissioning) is recommended.

3, the output current, rated current 2 a, 3 a biggest (need to add heat sink), if the output power is greater than 15 w, suggested that combined with heat sink

4, conversion efficiency: up to 92% (the higher the output voltage, the higher the efficiency)

5, static power consumption is only about 6 ma.

6. Because it is step-down module, in order to guarantee the stability of the output, please keep the minimum 1.5 V differential pressure.

Nature of the module
The isolation step-down (BUCK)
Rectifying way
The synchronous rectifier

The input voltage
3.2 V - 35 V
The output voltage
1.23 V - 30 V

The output current
3 a (Max)
Conversion efficiency
92% (highest)

Switching frequency
150 KHZ
The output ripple
30 mv (maximum)

Load regulation
Plus or minus 0.5%
Voltage regulation
Plus or minus 2.5%

Working temperature
- 40 ? to + 85 ?
The peripheral size
48 * 23.5 * 14 (length * width * height) (mm)

Abbiamo disponibili datasheet di tutti i componenti, qualora non fosse presente nella scheda download del prodotto inviaci un messaggio dal modulo contattaci e lo pubblicheremo il prima possibile nel nostro sito.