3d Printer Mega Ultimaker Shield Compatible with RAMPS

3d Printer Mega Ultimaker Shield Compatible with RAMPS

More details

New product

43,03 €

Immediately available

- +

Add to compare

Free Google QRcode module

More info

3d Printer Mega Ultimaker Shield Compatible with RAMPS

Ultimaker is a very popular controller board used in DIY 3D printers. It is possible to use this board with all tha boards contains Arduino Mega's pinout by doing nothing else after your plug it onto your Arduino Mega. Following this, it is fully compatible with the most popular stepper motor driver board A4988.

This board is very ideal if you are looking for a controller to make your own 3D printer or to change your printer's controller. Ultimaker has reached so many users for its opensource design info. and this made it more dveloped in time.

Ultimaker, Mendel and Prusa compatible Ramps allows control of 5 seperate stepper motor.

It is possible to use 5 A4988 motor driver board to control these stepper motors. The products does not include motor drivers. Ramps supports 5 different stepper motors; 1 for X axis, 1 for Y axis, 2 for Z axis and 2 for extruders. Additionally, it has 3 heater outs and 3 limit-switch inputs. Lastly, wiring of the Ramps compatible LCD screen is fulfilled by the particular connector on the board.



• Arduino Mega Shield
• Plug in all motors with simple 4-way JST connectors.
• Made for Ultimaker's UltiStepper Driver.
• Compatible with Pololu stepper driver boards.
• Controls up to 5 stepper motors (3 for the X, Y and Z axis one for an extruder (the "E axis"),
• optionally you can add another axis by adding a Pololu stepper driver.
• 3x 55 Amp MOSFETs outputs (with LED indicators. Actual current capability limited by PCB and connectors)
• All pins are broken out for maximum extensibility
• Runs from 15V to 19V.
• Three thermocouple inputs, or thermistor inputs. The 100K thermistor is recommended.
• Has an IDC header for adding an LCD panel
• A toggle-switch for powering up/down the board
• Easier to wire up thermocouples
• Includes a 12V regulator for an (always on) fan to cool the electronics.
• A PWM output with power for LED arrays and other lighting
• LCD backlight dimming can now be software controlled
• A serial I/O header for Bluetooth and Ethernet add-ons.



Abbiamo disponibili datasheet di tutti i componenti, qualora non fosse presente nella scheda download del prodotto inviaci un messaggio dal modulo contattaci e lo pubblicheremo il prima possibile nel nostro sito.


Write a review

3d Printer Mega Ultimaker Shield Compatible with RAMPS

3d Printer Mega Ultimaker Shield Compatible with RAMPS

Write a review


No customer reviews for the moment.

15 other products in the same category:

Compare 0

No products

To be determined Shipping
0,00 € Total

Check out