SmartRF04EB CC1110 CC2530 zigbee Emulator Programmer Sale

SmartRF04EB CC1110 CC2530 zigbee Emulator Programmer

SmartRF04EB CC1110 CC2530 zigbee Emulator Programmer

More details

ARD001456
New product

12,30 €

- +

Add to compare

Free Google QRcode module

 
More info

SmartRF04EB CC1110 CC2530 zigbee Emulator Programmer

SmartRF04EB, CC series wireless chip debugging tools that can be used CC11xx, CC24xx, CC25xx other series, supports common multiple debugging tools such as downloads, simulation, debugging, breakpoints, single-step, full-speed, erase, read, encryption and support for protocol analysis;
With IAR for MCS-51 compiler for seamless connectivity, such as IAR730B, IAR751, IAR760, IAR810;

Supports the following software tools: SmartRF Studio, SmartRF Flash Programmer, IEEE Address Programmer, Packet Sniffer;

Support OS: WINXP, WIN7;

 

         [Features and Performance]

Full version of the circuit, non-simplified, two-BUFFER output, stable, reliable, compatible with most domestic module pin;

 

Automatic recognition speed, download speed up to 150KB / S;
Available on the target board to provide 3.3V voltage;

Interface definition is the official standard version:

 

Product Description

 

Description
The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip (SoC) devices from Texas Instruments. CC Debugger also supports CCxxxx RF transceivers. In addition, CC Debugger is used for configuring the CC85xx devices with PurePath Wireless Configurator.

Key Features
Performance
Compatible with the original TI CC Debugger
Supported Operating Systems: Windows 2000, Windows xp sp2/sp3, Windows Vista 32bit, Windows 7 32bit
Target voltage: 1.2V~3.6V
Capable of powering the target board from the debugger
Operating temperature: 0°C~85°C
Supported Software
IAR Embedded Workbench For C8051
SmartRF Flash Programmer
SmartRF Studio
SmartRF Packet Sniffer
PurePath Wireless Configurator
Connects to PC
Computer connection via USB interface
Connects to target board
Target board connection via 10-pin IDC connector (2x5 2.54mm pitch)

LED Status
OFF: The debugger has no power or there is no valid firmware on the debugger.
AMBER (BOTH LEDS ON): The debugger is powered, but there is no valid firmware.
RED LED BLINKING: The Debugger is in Boot Recovery Mode.
RED LED ON: No device detected. This might be due to old firmware on the CC Debugger, or a problem with the hardware connection (make sure the target board is properly powered and connected correctly).
GREEN LED ON: The target device has been properly detected. It is possible to start programming/debugging.




Abbiamo disponibili datasheet di tutti i componenti, qualora non fosse presente nella scheda download del prodotto inviaci un messaggio dal modulo contattaci e lo pubblicheremo il prima possibile nel nostro sito.


Write a review

SmartRF04EB CC1110 CC2530 zigbee Emulator Programmer
SmartRF04EB CC1110 CC2530 zigbee Emulator Programmer

Write a review

 
Comments(0)

No customer reviews for the moment.

18 other products in the same category:

Compare 0

No products

To be determined Shipping
0,00 € Total

Prices are tax excluded

Check out